Baking Soda Hydrogen Generator

How To Build A Hydrogen Generator To Run Your Car On Water with Home Made HHO generator DIY for hybrid and electric cars that are saving people money from spending on oil companies.

I agree that saving the environment should be top priority alternative fuels such as vegetable oils, water or ethanol is key to saving the planet and running a cost efficient vehicle and increasing gas mileage.

Baking soda hydrogen generator is made from mixing vinegar, baking soda and water that causes a chemical reaction of carbon dioxide which can be captured into a inverted vessel with a tap, stainless steel is preferred over aluminum due to the mess it can cause in your tank.

If you decide to look for stainless steel at home depot many are using wall plates for plugs to make the baking soda hydrogen generator. Measuring baking soda can depend on the size of the container that you will be using.

Hydrogen gas generation with a table spoon of baking soda and distilled water in a sealed container with stainless steel plates, having the container filled with distilled water will cause a reaction called browns gas also known as HHO once it comes in contact with the baking soda mixture.

The hydrogen and oxygen that is being produced from the baking soda has been stated to be useful during combustion and has a high production of 7 to 8 amps from the generator.

Learn How to Build Your Own Hydrogen Generator using one of plans or guides found on ebay, the supplies needed can be found at any hardware or department store.

Working in a well-ventilated area is a must gas is flammable, and is lighter than air. Other things to consider is the Hydrogen embrittlement occurs when hydrogen interacts with steel under heat and pressure.

Hydrogen atoms are smaller than the molecular structure of steel so hydrogen is forced into the steel and methane pockets are created which expand and contract which cause weak points in the steel and it can eventually break down.

Things you will need to get started:

• Clear acrylic storage container with a lid with a rubber seal
• PVC pipe
• switch plate
• silicone for sealing
• large water bottle
• sodium or potassium hydroxide or baking soda

since many hydrogen generator companies do not address this issues you will need to research ceramic metal conditioners that provide cermet coating to protect and repair the engine from the damaging effects of hydrogen embrittlement.

Things you will need:

• HHo Conversions
• HHO Electrolytes
• HHO Brown's Gas
• HHo Diesel

Parts Information, Each unit measures 7" tall and 4" wide.1/4 inch elbows to connect to standard 1/4 automotive vacuum hose provided,1/4" tee connector to connect the vacuum line into an existing line on your vehicle.

As in the case of a 4 feet of automotive grade 1/4" vacuum hose, 4 feet of red positive primary automotive wire, 2 feet of black ground (negative) primary automotive wire1 30 amp automotive inline fuse holder with 15 amp fuse provided4 ring connectors, 2 butt connectors, 1 in-line connector 1/4" plexiglass core that is notched every 1/4" to prevent wires from shorting. Also slotted to fit snuggly together for long life and dependability.

Four Strands (480") of pure 316L .030" stainless steel wire on the positive and negative sides of generator which is the absolute best for hydrogen production and corrosion resistance. Either terminal can be used for positive.

A single unit consumes 2-6 amps which will not harm the alternator in any vehicle when properly installed.Bubbler adjuster to adjust air flow through the generator so you can regulate the air flow to push the hydrogen gas to your engine and cool the cell. Pressure relief safety valve to protect your investment 32 oz. jar and assembled cap